Hi, I hope this helps. Typically if we’re to be asked to put G10 in between the step and the mast I would refuse the job. If corrosion were the issue then I would refabricate the step out of aluminum and anodize the corrosion of the step problem will greatly reduced, never solved. If I were to put G10 under step, that would be done to replace the missing material after the butt was recut to remove the corroded portion of the mast.
To provide the best experiences, we and our partners use technologies like cookies to store and/or access device information. Consenting to these technologies will allow us and our partners to process personal data such as browsing behavior or unique IDs on this site and show (non-) personalized ads. Not consenting or withdrawing consent, may adversely affect certain features and functions.
Click below to consent to the above or make granular choices. Your choices will be applied to this site only. You can change your settings at any time, including withdrawing your consent, by using the toggles on the Cookie Policy, or by clicking on the manage consent button at the bottom of the screen.